Use of RCDs in the Making of Interlocked Pavements with Waste Collected at the Federal Institute of Amazonas – CMC
DOI:
https://doi.org/10.31686/ijier.vol7.iss10.1749Keywords:
construction waste, alternative aggregate, reuseAbstract
The area of construction is responsible for a large portion of non-renewable natural resources that generate environmental impacts, since the extraction of materials and extend in large scale as waste from renovations, works and demolitions, causing construction and demolition waste, known as RCDs. The aim of this study is to analyze the feasibility of reusing recycled waste from mortars, concrete and ceramic bricks in civil construction, as aggregates in the manufacture of interlocking blocks, in order to simulate the reality of the conventional block produced in the civil construction sector. For the tests, 6 concrete load specimens were molded with coarse aggregate and fine aggregate percentages, respectively: 50% and 25%, following the parameters of NBR 5738. It was possible to conclude that the interlocking pavement made with RCDs is useful. to improve the permeability of land, sidewalks and streets, enabling ordinary people within their homes to produce and apply them.
References
[1] CONOMA (National Environment Council). RESOLUTION No. 307, JULY 5, 2002. Criteria and procedures for the management of construction waste. DOU No. 136, 07/17/2002.
[2] Brazil. Law No. 12,305 of August 2, 2010. Establishes the National Policy on Solid Waste; amends Law No. 9,605 of February 12, 1998; and makes other arrangements. Art. 13 National Policy on Solid Waste. Official Journal of the Union - Section 1, of 03/08/2010.
[3] J.R. Mota. The destination of solid construction waste in Manaus: from the construction site to the final destination. Dissertation (Master) - Federal University of Pará. Belém, 2014.
[4] B.B. Matuti, G.P. Santana Reuse of construction waste and demolition in the manufacture of ceramic brick - a review. Scientia Amazonia, 2019. [access August 15, 2019]; volume 8: 1-13. Available at: http://www.scientia-amazonia.org ISSN: 2238.1910.
[5] Brazilian Standard, ABNTNBR 10.004: solid waste - classification. 2004. Rio de Janeiro- Rj. Second Edition May 31, 2004.
[6] LIMA, J. A.R. Proposed guidelines for the production and standardization of recycled construction waste and its applications in mortar and concrete.1999. 246p. Dissertation (Master) - School of Engineering of São Carlos, University of São Paulo. São Carlos, 1999.
[7] MOTTA, R. S. Laboratory study of recycled solid construction aggregate for low traffic paving. São Paulo, 2005. 161p. Thesis (Master's degree). Polytechnic School, University of São Paulo.
[8] Brazilian Standard. ABNT NBR 248: Aggregate - Determination of particle size composition. 2003. Rio de Janeiro - RJ. First Edition 30/07/2003.
[9] Brazilian Standard. ABNT NBR 5738: Concrete - Procedure for shaping and curing specimens. 2015. Rio de Janeiro- Rj. Second Edition 01.01.2015.
[10] TAVEIRA, A. F. S. Evaluation of the use of recycled concrete aggregate (ACR) as a substitute for fine aggregate in the manufacture of mortar and paving concrete parts. Manaus, 2010. 107p. Thesis (Master's degree). Federal University of Amazonas.
[11] Brazilian Standard. ABNT NBR 9781: Paving concrete parts - specification and test methods. 2013. Rio de Janeiro- Rj. SecondEdition 07.01.2013.
[12] Brazilian Standard. ABNT NBR 5739: Concrete - Compressiontestofcylindricalspecimens. 2018. Rio de Janeiro - RJ. Third Edition 05/30/2018.
[13] J.R.A CARDOSO. Use of Manaus - AM Civil Construction Rubble Aggregate to Obtain Cellular Mortar Block. Dissertation (Master) - Postgraduate Program in Mechanical and Materials Engineering, Federal Technological University of Paraná, Curitiba, 2010.
[14] S.F. BITTENCOURT. Evaluation of the compressive strength of pavers produced with construction and demolition waste aggregates and foundry sand. Dissertation (masters) - State University of Campinas, Faculty of Technology, Limeira-SP, 2012. 108 p.
[15] T.T. Lime; R.M. Castro; M.N. Castro Influence of recycled content on compressive strength and porosity of concrete. International Journal of Sciences. 2018. [access August 15, 2019]; Rio de Janeiro, v. 08, no. 01, p. 129 - 147, January-June 2018. Available at: http://www.e-publicacoes.uerj.br/ojs/index.php/ric.
[16] R.D. Barreto. Production of interlocking pavement with the use of construction waste as a small aggregate. Dissertation - University of Vale do Paraíba Faculty of Engineering, Architecture and Urbanism. Sao Jose dos Campos - SP, 2016.
[17] M.E. CAVALCANTI; P.R AMORIM; S.G. JUNIOR. Interlock paving: use of construction and demolition waste for the manufacture and laying of pavers XV-INIC⁄ X EPG. São Paulo- Jacarei, 2011. p. 03-04.
[18] ZORDAN, S. E. (1997). The use of rubble as aggregate in the manufacture of concrete. Campinas, 140p. Thesis (Master's degree). Faculty of Civil Engineering, State University of Campinas.
[2] Brazil. Law No. 12,305 of August 2, 2010. Establishes the National Policy on Solid Waste; amends Law No. 9,605 of February 12, 1998; and makes other arrangements. Art. 13 National Policy on Solid Waste. Official Journal of the Union - Section 1, of 03/08/2010.
[3] J.R. Mota. The destination of solid construction waste in Manaus: from the construction site to the final destination. Dissertation (Master) - Federal University of Pará. Belém, 2014.
[4] B.B. Matuti, G.P. Santana Reuse of construction waste and demolition in the manufacture of ceramic brick - a review. Scientia Amazonia, 2019. [access August 15, 2019]; volume 8: 1-13. Available at: http://www.scientia-amazonia.org ISSN: 2238.1910.
[5] Brazilian Standard, ABNTNBR 10.004: solid waste - classification. 2004. Rio de Janeiro- Rj. Second Edition May 31, 2004.
[6] LIMA, J. A.R. Proposed guidelines for the production and standardization of recycled construction waste and its applications in mortar and concrete.1999. 246p. Dissertation (Master) - School of Engineering of São Carlos, University of São Paulo. São Carlos, 1999.
[7] MOTTA, R. S. Laboratory study of recycled solid construction aggregate for low traffic paving. São Paulo, 2005. 161p. Thesis (Master's degree). Polytechnic School, University of São Paulo.
[8] Brazilian Standard. ABNT NBR 248: Aggregate - Determination of particle size composition. 2003. Rio de Janeiro - RJ. First Edition 30/07/2003.
[9] Brazilian Standard. ABNT NBR 5738: Concrete - Procedure for shaping and curing specimens. 2015. Rio de Janeiro- Rj. Second Edition 01.01.2015.
[10] TAVEIRA, A. F. S. Evaluation of the use of recycled concrete aggregate (ACR) as a substitute for fine aggregate in the manufacture of mortar and paving concrete parts. Manaus, 2010. 107p. Thesis (Master's degree). Federal University of Amazonas.
[11] Brazilian Standard. ABNT NBR 9781: Paving concrete parts - specification and test methods. 2013. Rio de Janeiro- Rj. SecondEdition 07.01.2013.
[12] Brazilian Standard. ABNT NBR 5739: Concrete - Compressiontestofcylindricalspecimens. 2018. Rio de Janeiro - RJ. Third Edition 05/30/2018.
[13] J.R.A CARDOSO. Use of Manaus - AM Civil Construction Rubble Aggregate to Obtain Cellular Mortar Block. Dissertation (Master) - Postgraduate Program in Mechanical and Materials Engineering, Federal Technological University of Paraná, Curitiba, 2010.
[14] S.F. BITTENCOURT. Evaluation of the compressive strength of pavers produced with construction and demolition waste aggregates and foundry sand. Dissertation (masters) - State University of Campinas, Faculty of Technology, Limeira-SP, 2012. 108 p.
[15] T.T. Lime; R.M. Castro; M.N. Castro Influence of recycled content on compressive strength and porosity of concrete. International Journal of Sciences. 2018. [access August 15, 2019]; Rio de Janeiro, v. 08, no. 01, p. 129 - 147, January-June 2018. Available at: http://www.e-publicacoes.uerj.br/ojs/index.php/ric.
[16] R.D. Barreto. Production of interlocking pavement with the use of construction waste as a small aggregate. Dissertation - University of Vale do Paraíba Faculty of Engineering, Architecture and Urbanism. Sao Jose dos Campos - SP, 2016.
[17] M.E. CAVALCANTI; P.R AMORIM; S.G. JUNIOR. Interlock paving: use of construction and demolition waste for the manufacture and laying of pavers XV-INIC⁄ X EPG. São Paulo- Jacarei, 2011. p. 03-04.
[18] ZORDAN, S. E. (1997). The use of rubble as aggregate in the manufacture of concrete. Campinas, 140p. Thesis (Master's degree). Faculty of Civil Engineering, State University of Campinas.
Downloads
- PDF 137 480
Published
2019-10-01
Issue
Section
Journal Articles
License
Copyright (c) 2019 Willians dos Santos Teixeira, Giselle Cunha do Nascimento, Lívia da Silva Oliveira, David Barbosa de Alencar
This work is licensed under a Creative Commons Attribution-NoDerivatives 4.0 International License.
Copyrights for articles published in IJIER journals are retained by the authors, with first publication rights granted to the journal. The journal/publisher is not responsible for subsequent uses of the work. It is the author's responsibility to bring an infringement action if so desired by the author for more visit Copyright & License.
How to Cite
dos Santos Teixeira, W., Cunha do Nascimento, G., da Silva Oliveira, L., & Barbosa de Alencar, D. (2019). Use of RCDs in the Making of Interlocked Pavements with Waste Collected at the Federal Institute of Amazonas – CMC. International Journal for Innovation Education and Research, 7(10), 90-96. https://doi.org/10.31686/ijier.vol7.iss10.1749
Most read articles by the same author(s)
- Ítalo Pedro Santos de Oliveira, Livia da Silva Oliveira, David Barbosa de Alencar, Manoel Henrique Reis Nascimento, Implementation of 288 KWP Photovoltaic Solar System On-Grid in a Manaus Industrial Polo Company , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Bruno Brande Gonçalves Rodrigues, Diego Oliveira Marinho, Sara dos Santos Santarém, Frank Henrique Santos Fontineles, David Barbosa de Alencar, Italo Rodrigo Soares Silva, Analysis of Labor Qualification in Civil Construction in Manaus Amazonas , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Ronaldo Lopes Gomes, Ricardo Chamy do Nascimento, Caio Victor da Silva Viga, Bruno Pereira Gonçalves, Jean Mark Lobo de Oliveira, Rilmar Pereira Gomes, David Barbosa de Alencar, Introduction of Basic Computer Programming Logic in Elementary and High Schools Using Logic Block , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Gabriel Barbosa Soares, Djanielson de Oliveira Pereira, Livia da Silva Oliveira, David Barbosa de Alencar, Manoel Henrique Reis Nascimento, Implementation of the TN-C-S Scheme in an Ungrounded Low Voltage Electrical Installation in Manaus / AM , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Vinícius Guilherme Pereira Vasconcelos, David Barbosa de Alencar, Alexandra Priscilla Tregue Costa, Marden Eufrasio dos Santos, Proposal for an Araçá-Boi Fruit Mead Factory in the Amazon Region , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Luiza Yanka Trindade Ribeiro, Livia da Silva Oliveira, David Barbosa de Alencar, Ricardo Silva Parente, Economic analysis of an automated lighting system with presence sensor at a state school in the city of Manacapuru-AM , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Gisele de Freitas Lopes, Manoel Henrique Reis Nascimento, Alexandra Amaro de Lima, Nadime Mustafa Moraes, José Roberto Lira Pinto Júnior, Ana Priscila Barbosa de Alencar, David Barbosa de Alencar, Application of the nonlinear autoregressive model with exogenous inputs for river level forecast in the Amazon , International Journal for Innovation Education and Research: Vol. 10 No. 3 (2022): International Journal for Innovation Education and Research
- Evilly Cardoso Gomes, Mikelly Pinheiro Garcia, Igor Bezerra de Lima, David Barbosa de Alencar, Antônio Estanislau Sanches, Technological Control Assessment and Concrete Receiving , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Candy Ace de Oliveira Monteiro, Fabiana Rocha Pinto, David Barbosa de Alencar, Gisele de Freitas Lopes, Applicability Study of ISO 14001: 2015 for Implementation of the Environmental Management System in an Electro-Electronic Industry in PIM , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Jean Barros Félix, David Barbosa de Alencar, Alexandra Priscilla Tregue Costa, Antônio Estanislau Sanches, Process Optimization on Rear Bumper Assembly in a PIM Two Wheels Poly Company , International Journal for Innovation Education and Research: Vol. 7 No. 9 (2019): International Journal for Innovation Education and Research