Tribological test of compressor used in the refrigeration industry
DOI:
https://doi.org/10.31686/ijier.vol8.iss11.2729Keywords:
Tribology, wear, compressorAbstract
The article describes the analytical procedures and acceptance criteria for analysis of compressor and components with a focus to tribological aspects. In the introduction, the article deals with tribology as a scientific discipline. Subsequently, the article describes different kinds of wear, which may occur during the operation of compressor at different levels. Subsequently, the article mentions the equipment used in the test. At the end the results of the test are summarized with complete photo-documentation.
References
An important anniversary of tribology and tribotechnics in Slovakia [online], cit. [2020-09-14], online in: <https://www.engineering.sk/clanky2/tribologia-a-tribotechnika/3793-vyznamne-vyrocie-tribologie-a-tribotechniky-na-slovensku>
DZIMKO, M. : Úlohy a význam tribológie v technických systémoch, Workshop Žilina, 25.
Kvalifikácia opotrebenia podľa STN 01 5050 [online], 2010, cit: [2020-09-14], Online in: <http://www.kvalitaprodukcie.info/12-klasifikacia-opotrebenia-podla-stn-01-5050/comment-page-1/>
Downloads
Published
Issue
Section
License
Copyright (c) 2020 Lubica Bednarova
This work is licensed under a Creative Commons Attribution-NoDerivatives 4.0 International License.
Copyrights for articles published in IJIER journals are retained by the authors, with first publication rights granted to the journal. The journal/publisher is not responsible for subsequent uses of the work. It is the author's responsibility to bring an infringement action if so desired by the author for more visit Copyright & License.
How to Cite
Accepted 2020-10-18
Published 2020-11-01
Most read articles by the same author(s)
- Lubica Bednarova, Lukáš Tóth, Tomáš Brestovič, Natália Jasminská, Marián Lázár, Romana Dobáková, Thermal and energy balance of a fuel cell during hydrogen supply from metal hydride materials , International Journal for Innovation Education and Research: Vol. 8 No. 11 (2020): International Journal for Innovation Education and Research
- Lubica Bednarova, Tomáš Brestovič, Natália Jasmisnká, Marián Lázár, Romana Dobáková, Lukáš Tóth, The impact of metal hydride material activation to storage percentage of hydrogen in this material , International Journal for Innovation Education and Research: Vol. 8 No. 1 (2020): International Journal for Innovation Education and Research
- Ľubomíra Kmeťová, Marián Lázar, Natália Jasminská, Romana Dobáková, Potential Applications of Vitrified Slag as a Product of Plasma Arc Melting , International Journal for Innovation Education and Research: Vol. 9 No. 11 (2021): International Journal for Innovation Education and Research
- Lubica Bednarova, Lukáš Tóth, Tomáš Brestovič, Natália Jasminská, Marián Lázár, Romana Dobáková, Possibilities of utilization of waste heat of synthesis gas , International Journal for Innovation Education and Research: Vol. 8 No. 1 (2020): International Journal for Innovation Education and Research
- Lukas Toth, Tomas Brestovic, Natalia Jasminska, Absorption of Hydrogen in the HBond©9000 Metal Hydride Tank , International Journal for Innovation Education and Research: Vol. 6 No. 11 (2018): International Journal for Innovation Education and Research
- Lubica Bednarova, Romana Dobáková, Marián Lázár, Natália Jasminská, Tomáš Brestovič, Ľubomíra Kmeťová, The Assessment of the Environmental Impact of Selected Plastics , International Journal for Innovation Education and Research: Vol. 8 No. 11 (2020): International Journal for Innovation Education and Research
- Marián Lázár, Filip Duda, Ľubomíra Kmeťová, Natália Jasminská, Šimon Hudák, Design and calculation of heat transfer of the passive cooling modules for low-pressure hydrogen vessels , International Journal for Innovation Education and Research: Vol. 9 No. 11 (2021): International Journal for Innovation Education and Research
- Filip Duda, Šimon Hudák, Tomáš Brestovič, Marián Lázár, Design of internal heat transport intensifier for metal hydride storage tank , International Journal for Innovation Education and Research: Vol. 9 No. 11 (2021): International Journal for Innovation Education and Research
- Lukas Toth, Natalia Jasminska, Tomas Brestovic, Romana Dobakova, Model of a Hydrogen Vehicle Driven by a Fuel Cell and Metal Hydride Materials , International Journal for Innovation Education and Research: Vol. 6 No. 11 (2018): International Journal for Innovation Education and Research