Use of RCDs in the Making of Interlocked Pavements with Waste Collected at the Federal Institute of Amazonas – CMC
DOI:
https://doi.org/10.31686/ijier.vol7.iss10.1749Keywords:
construction waste, alternative aggregate, reuseAbstract
The area of construction is responsible for a large portion of non-renewable natural resources that generate environmental impacts, since the extraction of materials and extend in large scale as waste from renovations, works and demolitions, causing construction and demolition waste, known as RCDs. The aim of this study is to analyze the feasibility of reusing recycled waste from mortars, concrete and ceramic bricks in civil construction, as aggregates in the manufacture of interlocking blocks, in order to simulate the reality of the conventional block produced in the civil construction sector. For the tests, 6 concrete load specimens were molded with coarse aggregate and fine aggregate percentages, respectively: 50% and 25%, following the parameters of NBR 5738. It was possible to conclude that the interlocking pavement made with RCDs is useful. to improve the permeability of land, sidewalks and streets, enabling ordinary people within their homes to produce and apply them.
References
[1] CONOMA (National Environment Council). RESOLUTION No. 307, JULY 5, 2002. Criteria and procedures for the management of construction waste. DOU No. 136, 07/17/2002.
[2] Brazil. Law No. 12,305 of August 2, 2010. Establishes the National Policy on Solid Waste; amends Law No. 9,605 of February 12, 1998; and makes other arrangements. Art. 13 National Policy on Solid Waste. Official Journal of the Union - Section 1, of 03/08/2010.
[3] J.R. Mota. The destination of solid construction waste in Manaus: from the construction site to the final destination. Dissertation (Master) - Federal University of Pará. Belém, 2014.
[4] B.B. Matuti, G.P. Santana Reuse of construction waste and demolition in the manufacture of ceramic brick - a review. Scientia Amazonia, 2019. [access August 15, 2019]; volume 8: 1-13. Available at: http://www.scientia-amazonia.org ISSN: 2238.1910.
[5] Brazilian Standard, ABNTNBR 10.004: solid waste - classification. 2004. Rio de Janeiro- Rj. Second Edition May 31, 2004.
[6] LIMA, J. A.R. Proposed guidelines for the production and standardization of recycled construction waste and its applications in mortar and concrete.1999. 246p. Dissertation (Master) - School of Engineering of São Carlos, University of São Paulo. São Carlos, 1999.
[7] MOTTA, R. S. Laboratory study of recycled solid construction aggregate for low traffic paving. São Paulo, 2005. 161p. Thesis (Master's degree). Polytechnic School, University of São Paulo.
[8] Brazilian Standard. ABNT NBR 248: Aggregate - Determination of particle size composition. 2003. Rio de Janeiro - RJ. First Edition 30/07/2003.
[9] Brazilian Standard. ABNT NBR 5738: Concrete - Procedure for shaping and curing specimens. 2015. Rio de Janeiro- Rj. Second Edition 01.01.2015.
[10] TAVEIRA, A. F. S. Evaluation of the use of recycled concrete aggregate (ACR) as a substitute for fine aggregate in the manufacture of mortar and paving concrete parts. Manaus, 2010. 107p. Thesis (Master's degree). Federal University of Amazonas.
[11] Brazilian Standard. ABNT NBR 9781: Paving concrete parts - specification and test methods. 2013. Rio de Janeiro- Rj. SecondEdition 07.01.2013.
[12] Brazilian Standard. ABNT NBR 5739: Concrete - Compressiontestofcylindricalspecimens. 2018. Rio de Janeiro - RJ. Third Edition 05/30/2018.
[13] J.R.A CARDOSO. Use of Manaus - AM Civil Construction Rubble Aggregate to Obtain Cellular Mortar Block. Dissertation (Master) - Postgraduate Program in Mechanical and Materials Engineering, Federal Technological University of Paraná, Curitiba, 2010.
[14] S.F. BITTENCOURT. Evaluation of the compressive strength of pavers produced with construction and demolition waste aggregates and foundry sand. Dissertation (masters) - State University of Campinas, Faculty of Technology, Limeira-SP, 2012. 108 p.
[15] T.T. Lime; R.M. Castro; M.N. Castro Influence of recycled content on compressive strength and porosity of concrete. International Journal of Sciences. 2018. [access August 15, 2019]; Rio de Janeiro, v. 08, no. 01, p. 129 - 147, January-June 2018. Available at: http://www.e-publicacoes.uerj.br/ojs/index.php/ric.
[16] R.D. Barreto. Production of interlocking pavement with the use of construction waste as a small aggregate. Dissertation - University of Vale do Paraíba Faculty of Engineering, Architecture and Urbanism. Sao Jose dos Campos - SP, 2016.
[17] M.E. CAVALCANTI; P.R AMORIM; S.G. JUNIOR. Interlock paving: use of construction and demolition waste for the manufacture and laying of pavers XV-INIC⁄ X EPG. São Paulo- Jacarei, 2011. p. 03-04.
[18] ZORDAN, S. E. (1997). The use of rubble as aggregate in the manufacture of concrete. Campinas, 140p. Thesis (Master's degree). Faculty of Civil Engineering, State University of Campinas.
[2] Brazil. Law No. 12,305 of August 2, 2010. Establishes the National Policy on Solid Waste; amends Law No. 9,605 of February 12, 1998; and makes other arrangements. Art. 13 National Policy on Solid Waste. Official Journal of the Union - Section 1, of 03/08/2010.
[3] J.R. Mota. The destination of solid construction waste in Manaus: from the construction site to the final destination. Dissertation (Master) - Federal University of Pará. Belém, 2014.
[4] B.B. Matuti, G.P. Santana Reuse of construction waste and demolition in the manufacture of ceramic brick - a review. Scientia Amazonia, 2019. [access August 15, 2019]; volume 8: 1-13. Available at: http://www.scientia-amazonia.org ISSN: 2238.1910.
[5] Brazilian Standard, ABNTNBR 10.004: solid waste - classification. 2004. Rio de Janeiro- Rj. Second Edition May 31, 2004.
[6] LIMA, J. A.R. Proposed guidelines for the production and standardization of recycled construction waste and its applications in mortar and concrete.1999. 246p. Dissertation (Master) - School of Engineering of São Carlos, University of São Paulo. São Carlos, 1999.
[7] MOTTA, R. S. Laboratory study of recycled solid construction aggregate for low traffic paving. São Paulo, 2005. 161p. Thesis (Master's degree). Polytechnic School, University of São Paulo.
[8] Brazilian Standard. ABNT NBR 248: Aggregate - Determination of particle size composition. 2003. Rio de Janeiro - RJ. First Edition 30/07/2003.
[9] Brazilian Standard. ABNT NBR 5738: Concrete - Procedure for shaping and curing specimens. 2015. Rio de Janeiro- Rj. Second Edition 01.01.2015.
[10] TAVEIRA, A. F. S. Evaluation of the use of recycled concrete aggregate (ACR) as a substitute for fine aggregate in the manufacture of mortar and paving concrete parts. Manaus, 2010. 107p. Thesis (Master's degree). Federal University of Amazonas.
[11] Brazilian Standard. ABNT NBR 9781: Paving concrete parts - specification and test methods. 2013. Rio de Janeiro- Rj. SecondEdition 07.01.2013.
[12] Brazilian Standard. ABNT NBR 5739: Concrete - Compressiontestofcylindricalspecimens. 2018. Rio de Janeiro - RJ. Third Edition 05/30/2018.
[13] J.R.A CARDOSO. Use of Manaus - AM Civil Construction Rubble Aggregate to Obtain Cellular Mortar Block. Dissertation (Master) - Postgraduate Program in Mechanical and Materials Engineering, Federal Technological University of Paraná, Curitiba, 2010.
[14] S.F. BITTENCOURT. Evaluation of the compressive strength of pavers produced with construction and demolition waste aggregates and foundry sand. Dissertation (masters) - State University of Campinas, Faculty of Technology, Limeira-SP, 2012. 108 p.
[15] T.T. Lime; R.M. Castro; M.N. Castro Influence of recycled content on compressive strength and porosity of concrete. International Journal of Sciences. 2018. [access August 15, 2019]; Rio de Janeiro, v. 08, no. 01, p. 129 - 147, January-June 2018. Available at: http://www.e-publicacoes.uerj.br/ojs/index.php/ric.
[16] R.D. Barreto. Production of interlocking pavement with the use of construction waste as a small aggregate. Dissertation - University of Vale do Paraíba Faculty of Engineering, Architecture and Urbanism. Sao Jose dos Campos - SP, 2016.
[17] M.E. CAVALCANTI; P.R AMORIM; S.G. JUNIOR. Interlock paving: use of construction and demolition waste for the manufacture and laying of pavers XV-INIC⁄ X EPG. São Paulo- Jacarei, 2011. p. 03-04.
[18] ZORDAN, S. E. (1997). The use of rubble as aggregate in the manufacture of concrete. Campinas, 140p. Thesis (Master's degree). Faculty of Civil Engineering, State University of Campinas.
Downloads
- PDF 137 480
Published
2019-10-01
Issue
Section
Journal Articles
License
Copyright (c) 2019 Willians dos Santos Teixeira, Giselle Cunha do Nascimento, Lívia da Silva Oliveira, David Barbosa de Alencar
This work is licensed under a Creative Commons Attribution-NoDerivatives 4.0 International License.
Copyrights for articles published in IJIER journals are retained by the authors, with first publication rights granted to the journal. The journal/publisher is not responsible for subsequent uses of the work. It is the author's responsibility to bring an infringement action if so desired by the author for more visit Copyright & License.
How to Cite
dos Santos Teixeira, W., Cunha do Nascimento, G., da Silva Oliveira, L., & Barbosa de Alencar, D. (2019). Use of RCDs in the Making of Interlocked Pavements with Waste Collected at the Federal Institute of Amazonas – CMC. International Journal for Innovation Education and Research, 7(10), 90-96. https://doi.org/10.31686/ijier.vol7.iss10.1749
Most read articles by the same author(s)
- Wendel Júlio Silva Barroso, David Barbosa de Alencar, Alexandra Priscilla Tregue Costa, Antônio Estanislau Sanches, Implementation of 5S Program in a Building Site of a Predial Reform in Manaus City , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Denilson Fernandes Vital, David Barbosa de Alencar, Mauro Cezar Aparício De Souza, Alexandra Priscilla Tregue Costa, Francisco Carlos Tavares Amorim, Ana Jaqueline Travessa Amorim, Carlos Eduardo de Oliveira, Optimization of the Production Process of Sealing Bricks in a Ceramic Factory in Urucurituba City in Amazonas – Brazil , International Journal for Innovation Education and Research: Vol. 7 No. 10 (2019): International Journal for Innovation Education and Research
- Samuel Cameli Fernandes, Laerte Melo Barros, Rodrigo Paz Barros, Pedro Felix Liotto, David Barbosa de Alencar, Concrete Production Using Fine Glass Aggregates as Partial Replacement of Sand , International Journal for Innovation Education and Research: Vol. 7 No. 12 (2019): International Journal for Innovation Education and Research
- Lourival Cordeiro da Silva, Viviane Cristiny dos Santos Mendonça, Igor Bezerra de Lima, David Barbosa de Alencar, Camily Murrieta Vasconcelos Oliveira Bezerra, Preventive and Corrective Predial Inspection and Maintenance: A Case Study in a Residential Building in Amazonas , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Lucas Dias Melo, Jeann Alef Pereira Rodrigues, Kalebe Carmo Caldas, Bruno Pereira Gonçalves, Jean Mark Lobo de Oliveira, David Barbosa de Alencar, Mobile App Interface Development for Tourism , International Journal for Innovation Education and Research: Vol. 7 No. 10 (2019): International Journal for Innovation Education and Research
- Hemerson Allan Silva de Moraes, Bruno Pereira Gonçalves, Aline Mary Moreira de Melo, Jean Mark Lobo de Oliveira, David Barbosa de Alencar, Intelligent Automation System in Asset Safety Using Household , International Journal for Innovation Education and Research: Vol. 8 No. 4 (2020): International Journal for Innovation Education and Research
- Diana Trindade Duarte, David Barbosa de Alencar, Alexandra Priscilla Tregue Costa, Antônio Estanislau Sanches, Reducing Process Setup in a Smart TV Card Factory , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Tamires Lima de Souza, David Barbosa de Alencar, Alexandra Priscilla Tregue Costa, Mauro Cezar Aparício de Souza, Proposal for Implementation of a Kanban System in the Auxiliary Inventory Sector in a Auto Parts Company , International Journal for Innovation Education and Research: Vol. 7 No. 10 (2019): International Journal for Innovation Education and Research
- Kédson Cruz da Silva, David Barbosa de Alencar, Alexandra Priscilla Tregue Costa, Antônio Estanislau Sanches, Application of Swot Analysis in the Distributor Company and Commercial Market Souza Cruz , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research
- Luciano Oliveira de Melo, David Barbosa de Alencar, Alexandra Priscilla Tregue Costa, Marden Eufrasio dos Santos, Transport Logistics Analysis of Amazon Application , International Journal for Innovation Education and Research: Vol. 7 No. 11 (2019): International Journal for Innovation Education and Research